Had a small shopper’s IT request our assist with some loop points of their community.
Loop safety was on and was triggering, however they may not perceive what was responsible for the loop.
After poking round noticed that loop safety was triggering on ports with Ubiquity APs related to them. I used to be like “Huh, that may’t be proper…” After some extra pocking round nothing else appeared be the perpetrator so determined to examine the Ubiquity AP config. End up mesh performance was on and the AP determined to make a mesh community out of the blue (by no means occurred earlier than).
Turning mesh off solved the issue. Albeit some AP refused to show it off and needed to be reset.
